Skip to end of metadata
Go to start of metadata

This section describes the procedure for changing the CE name, peer CE name, and/or system name.

Note: This procedure is not mandatory and is used to change the node name only if required. It will also impact the service.
  1. Shut down the SBC application on the standby system.
    service sbx stop
  2. Run nameChange.pl script on the active system. Usage is:
    /opt/sonus/sbx/scripts/nameChange.pl [-h] [-c new_ce_name] [-p new_peer_ce_name] [-s new_system_name] [-l level] [-L level]
    where,
    -h: Prints usage statement
    -c: Changes the CE name (and hostname) to the specified name
    -p: Changes the peer CE name to the specified name
    -s: Changes the system name to the specified name
    -l: Force confd debug level
    where, 0 - SILENT, 1 - DEBUG, 2 - TRACE
    -L: Force pstrace level
    where, 0 - SILENT, 1 - TRACE, 2 - VERB

    • This script must be run on both active and standby systems.
    • Stop the SBC application on both the standby and active systems, and then run the nameChange.pl script on both active and standby systems.
    • One of the -c, -p, or -s options must be specified.
  3. Once the active system successfully finishes updating, run nameChange.pl script on the standby system. 

    The active and standby systems accept different arguments since the CE name/peer name depends on which system you are running on.
  4. Start the SBC application active system.
    service sbx start

  5. Start the service on the standby system.
    service sbx start

  • No labels