Skip to end of metadata
Go to start of metadata

 

Unlike a Controlled Partition Upgrade, the Sonus SBC 1000/2000 provides a "One-Step Upgrade" solution which automatically upgrades the currently inactive partition, makes it active, and boots the Sonus SBC 1000/2000 from the newly upgraded partition. Sonus recommends using this One-Step Upgrade operation after Running Initial Setup, or during scheduled downtime.

Please Read!

You must follow the instructions outlined in the general Sonus SBC 1000/2000 Upgrade guide before you proceed with the steps outlined on this page. The general upgrade guide includes important prerequisites for Sonus SBC 1000/2000 systems with a built-In Application Solution Module (ASM), and also describes which firmware files to use depending on the Sonus SBC 1000/2000 Model you are using.

The Software Upload progress bar is supported in the following browsers:

  • Internet Explorer, Releases 10 and 11
  • Firefox, Release 24 and later
  • Chrome, Release 31 and later

In browsers that do not support this feature, the software upgrade process will be presented the way it is shown in Release 4.0 and previous.

Automatically Upgrading the Sonus SBC 1000/2000 Software/Firmware Version

To automatically upgrade the Sonus SBC 1000/2000 software:

  1. In the WebUI, click the Tasks tab.
  2. In the left navigation pane, click System > Firmware Upgrade.

  3. Perform a Backup on the configuration file.

  4. Enter an optional Passphrase (see Using the Custom Passphrase).                                                    

  5. Under Select File, click the Browse button and select the Sonus SBC 1000/2000 firmware file listed in the general Sonus SBC 1000/2000 Upgrade guideto upload.

     

  6. Click Upgrade. The following warning popup will be displayed:

  7. Click OK to upload the new firmware. Do not close or navigate away from the browser window, or you may receive partial results. Throughout the upload process, the web interface displays update messages to indicate the progression of the upgrade, as shown below. (If you navigate to this view from another browser, it will also display the progress.) Once the upgrade is complete, the system automatically reboots.

An average upgrade takes about 8 - 9 minutes. During the upgrade process, the remaining time estimates in the different steps becomes more accurate as the process progresses.

Helpful Tip

On average, the Sonus SBC 1000/2000 system takes between 3 to 4 minutes to fully reboot and become reachable again through the web interface.
Upon completion, you will be automatically redirected to the Login screen. Verify that you are booting from the new partition either by checking the active partition, or by Viewing the Software Version.