Skip to end of metadata
Go to start of metadata

Not supported by SBC SWe Lite in this release.

If necessary, you can reboot or reset the ASM from this task. Reboot instructs the ASM operating system to restart (a "clean" reboot), equivalent to rebooting a PC from the Start menu. The Hardware Reset task abruptly resets the ASM (a "dirty" reboot), equivalent to interrupting the power.

The Reboot option is recommended in all cases, and Reset should only be used when the ASM is not responding to other commands.

Rebooting the ASM

Before you Begin

This operation can only be performed when the Sonus SBC 1000/2000 Communication service becomes operational. In other words, only when a valid ASM IP address has been configured either via the Initial Setup or the ASM IP Settings.
  1. In the WebUI, click the Tasks tab.
  2. In the left navigation pane, under the Application Solution Module, click Shut Down/Reset/Reboot.

    Figure : Reboot ASM

  3. Select Reboot the Card
  4. Click Apply

A current activity status window will be displayed until the reboot is complete and the node is reachable

Resetting the ASM

  1. In the WebUI, click the Tasks tab.
  2. In the left navigation pane, under the Application Solution Module, click Shut Down/Reset/Reboot.

    Figure : Reset ASM

  3. Select Hardware Reset of Card
  4. Click Apply

A current activity status window will be displayed until the reboot is complete and the card is reachable.