Skip to end of metadata
Go to start of metadata

Figure : Front Panel

#

Name

Description

1

Reset

System reset button. For more information, see Resetting the Sonus SBC 1000-2000 to Factory Defaults.

2

USB Ports

USB ports for Sonus SBC 1000/2000 main board

3

Power

Power Status LED

4

Alarm

Alarm Status LED

5

Peer Node

Peer Node Status LED (also recognized as the Locator LED)

6

Ready

Ready Status LED

7

Admin Port

System Administration Ethernet Portdo not connect to your live network - see warning below

8

Ports 1 - 4

Ethernet Ports 1 - 4

9

USB Ports

USB ports for the Application Service Module (ASM) (when installed)

10

Expansion Bay

Future expansion bay

11

Expansion Bay

Networking expansion bay

12Ethernet Port StatusEthernet Status LED

 Admin Port

The Administrative IP port should be used for Running Initial Setup as well as all management related functionality from the web browser.

Application Ethernet Ports

When two or more LAN Ethernet ports are on the same Bridge (as in the factory-default Sonus SBC 1000/2000 configuration), they must not be connected to the same Ethernet switch or Ethernet network. Doing so creates a broadcast loop in the Ethernet network, rendering the network unusable. You may work around this issue by connecting the Ethernet ports directly to an intelligent switch or router running a spanning tree protocol.