Not supported by SBC SWe Lite in this release.
This article describes the steps necessary for configuring the Sonus SBC 1000 to route incoming PSTN calls to an FXS port. In the example below, ISDN/PSTN calls arriving with four digits are routed to an FXS port.
The process comprises four overall steps:
The FXS card does not function with older versions of the Sonus SBC 1000 firmware/software. Should you need to upgrade your Sonus SBC 1000 unit, you must follow the Sonus SBC 1000/2000 Upgrade Guide.
The Sonus SBC 1000 system must have the necessary licenses to make calls. In addition to CAS and DSP channels, and depending upon the types of calls, the Transcoding and SIP calls licenses may also be necessary as shown below:
Verify that the state for the Telco Module(s) indicated in the Cards/Modules Status pane is Activated.
Verify that the Admin State and Service Status for each port indicates Up as shown below.
FXS not Activated and Up? Did you upgrade the boot image and Sonus SBC 1000 base software versions as outlined above.
Verify that your FXS devices are connected to the ports you plan to configure.
Later in this article, you will create a CAS Signaling Group and assign channels and ports, they must match the physical ports to which the FXS devices are connected. See the figure below.
The FXS Ports and Channels in a CAS Signaling Group
The FXS Monitoring View
Create an FXS Signaling Profile for CAS.
Create an Assigned Channel and apply the desired phone number to the corresponding FXS port.
You may add all of the port/number combinations for FXS in a single Signaling Group.
Verify that the CAS Signaling group is configured as shown below.
Are you certain your boot image and Sonus SBC 1000/2000 software versions are up to date as noted in the Prerequisites?
In order to route incoming ISDN calls with 4 digits to FXS ports, you must create a Transformation table whose entry prepends
+1510574. The resulting called number, +1510574xxxx, then matches the Channel Phone Numbers configured in the previous section.
Create a Transformation Table for the FXS calls called PSTN to FXS:
Create a Transformation entry to that table called PSTN to FXS Transformation.
Add a call route table called From ISDN to SIP.
Add a call route entry to that table which employs the transformation created in the previous step called PSTN to FXS.
Resequence the FXS call route.
Calls should now work from ISDN to FXS.
Try reseating the DSP cards and telephony feature cards. Also, re-verify your licenses.
The Sonus SBC 1000 logging trace produced was saved when making the FXS call - you can download it here.