Skip to end of metadata
Go to start of metadata

It is necessary to add the rack ears to the VX1200 prior to installation either in a rack or cabinet.

  1. From the accessory kit, remove the two (2) rack ears and eight (8) #4 x 1/4th screws.
  2. Place the VX1200 on a clean level work surface.
  3. From each side of the VX1200, remove the bottom screw at the front of the unit (note, do not use these screws to hold in the rack ear as they are too short).
  4. Place the ears flush with front of the VX1200 and using a #2 Phillips screw driver, securely fasten the #4 x 1/4th screws in place. 

Reversing the rack ears is not supported


Rack Ear Screw Locations

  • No labels