Use tools and procedures in this section to set parameters for specified IP interface peers.
View IP Interface Peers
Select the Networking > Ethernet Adapters > Peer Table .
Add IP Interface Peers
Insert a new line in the Peers Table screen, then double-click the line to present the Edit Peer dialog box.
Modify IP Interface Peers
Double-click on table line in the Peer Table.
Select to enable or disable the peers.
Select the peer type from the drop down box. Options include VX node, ICMP or SIP Options.
The Node ID of the remote VX.
The IP address or FQDN of the remote VX. If the Peer type is set to BSP, ICMP, or SIP-Options, this field is IPAddress/FQDN. IP address format is IPv4/IPv6. The example is shown in IPv6 format.
Ignore Port Match
Check the box to configure checking of the LQM status of the peer with or without the port specified.
Specifies how long to wait for voice packets before the packet is dispatched
Specifies how much to raise the metric of the route if the first call fails.
Specifies the duration waited for failed calls to a node before increasing the priority of a route
Select the DiffServ Level from the drop down dialog box.
Pings to Reactivate Peer
Enter the number of pings required to bring up a LQM link.
Pings to Deactivate Peer
Enter the number of failed pings required to bring a LQM link down.
Select the radio button and enter the number of seconds for the ping interval. This specifies how frequently to send the Link Quality Management pings to determine the round trip delay of the link.