Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Log on to SBC BMC using the IP address configured in the previous section.

    Username: <username>
    Password: <default password>

    The SBC BMC main screen appears.

    Caption
    0Figure
    1BMC Main Screen

  2. Click Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

    Caption
    0Figure
    1Configuration Screen

    Note
    Info
    iconfalse
    titleNote

    A message appears to enter the management IP addresses for the first time installation. 

    Caption
    0Figure
    1Warning Message

  3. Click OK.

  4. Configure the following network settings for both the Management Interface 0 and 1.

    - IPv4 Address or/and IPv6 Address
    - Prefix
    - Default Gateway

  5. Click Save.

    Caption
    0Figure
    1Platform Management Network Settings


    Note
    Info
    iconfalse
    titleNote

    When coming from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address, this mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC. 

    Note
    Info
    iconfalse
    titleNote

    If you are updating a new Management IP address through BMC and click Save, reinstall the SBC application software (see the message appears in the below figure). Updating management IP using CLI/EMS/EMA will get updated automatically in BMC and re-installation is not required. 

    Caption
    0Figure
    1Warning Message




...