Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

How Call Routing Works

In the Sonus SBC 1000/2000 system

Spacevars
0product
 (SBC), all call routing occurs between Signaling Groups.

...

In order to route any call to or from a call system connected to Sonus SBC 1000/2000, you must first configure a Signaling Group to represent that device or system. The following list illustrates the hierarchical relationships of the various Telephony routing components of a Sonus SBC 1000/2000 call system:

Signaling Group — describes the source call and points to a routing definition known as a Call Route Table
  → Call Route Table — contains one or more Call Route Entries
         → Call Route Entries → points to the destination Signaling Group(s)

...

The diagram below illustrates possible paths of a call from an external call from a ISDN PRI service line connected to the Sonus SBC 1000/2000 system to an internal Lync 2010 server or analog phone or fax devices connected to a Tenor Analog device.

Panel
borderStylenone
Caption
0Figure
1Logic Path

 

...

SBC

...

Call Logic Steps

  1. An outside call comes through the ISDN PRI line connected to the Sonus SBC 1000/2000 system and is routed to the ISDN Signaling Group.

  2. In order to route the call, the Sonus SBC 1000/2000 ISDN Signaling Group system engages the Call Route Table attached to it.

  3. Sonus SBC 1000/2000 processes the Call Route Table entries and their attached Transformation Table entries, looking for a match to the called number.
    1. Sonus SBC 1000/2000 finds a match for a 4xxx local extension managed by a Lync 2010 Server.
    2. Sonus SBC 1000/2000 finds a match for a x2001 or x2002 local extension analog device, managed by a Tenor Analog system.

  4. Sonus SBC 1000/2000 routes the call to the appropriate Signaling Group and the receiving system processes the call.

...

Children Display
depth3
styleh5

Pagebreak