|Text||Configuring SBC with Level 3 Voice Complete|
- July 31, 2014
| ||This document provides a configuration guide for Sonus SBC 5000 Series (Session Border Controller) when connecting to Level 3 Voice Complete. The Sonus SBC is the point of connection between the PBX and the Level 3 Voice Complete. A configuration for a generic PBX was also included to provide context of the Level 3 Voice Complete solution. Sonus provides Application Notes for specific PBX vendors as well and if available, the more specific PBX Application Note should be used in place of the generic PBX section of this document.|
|Text||Configuring SBC with Genesys Platform Solutions|
C0000000PVOH/oVBlyCybPrZNdU98pa0EHOeK8CzwrTipkJG1zUiSCJI= - May 23, 2014
|Text||Ribbon SBC Geographic Redundancy Deployment Guide|
configuration Sonus SBC 5000 Series
- Revision 1.2 , January 2, 2019
This document provides a
when connecting to the Genesys SIP Server and other internal PBX systems. The Sonus SBC is the point of connection between the Genesys System and local PBX Systems that hosts internal SIP phones. The Sonus SBC is also the point of connection to external carrier SIP trunk providers for SIP Carrier connection. In this case, the internal PBX is out of scope of this document.
deploying a single Ribbon SBC Core platform (Session Border Controller)
- August 18, 2014
|Text||Configuring SBC with Carrier SIP Trunks and IP PBX Systems|
This document provides a configuration guide for Sonus SBC 5000 Series (Session Border Controller) when connecting one or more generic SIP-capable PBX systems and one or more SIP carriers. If there is a Sonus Application Note available for the specific PBX or SIP carrier, then that configuration should take precedence over the generic configuration presented in this document. The Sonus SBC is the point of connection between the PBX and the SIP Carrier.
in a Geographic Redundant manner. While this document attempts to document some best practices and configuration examples for deploying Ribbon SBC platforms, deployments done under the auspices of the Ribbon Network Design group should always take precedence over generic recommendations if there are any differences.
|Configuring SBC for Basic Audio Transcoding or Pass-Through Scenarios|
C0000000PVOR/z_Fr0EEozlDQPFJEKwEKBpAOcWxiqO7gfGlrqeTcb5Q= - May 14, 2014
|Ribbon SBC Signaling and Media Deployment Guide|
Sonus SBC 5000 Series
- Revision 1.1 , March 16, 2017
This document provides a planning and configuration guide for
for generic simple audio transcoding or audio pass-through between two or more peers (such as external SIP carriers or internal PBX systems) the SBC 5000 media interworking controls provide a lot of flexibility, this Application Note is focused on basic audio transcoding scenarios that minimize complexity with a configuration that attempts to maximize success for calls requiring audio transcoding. This document will use the term transcoding, generically, for any type of audio interworking, not simply translating between different codecs. Hardware-based DSPs (Digital Signal Processors) within the SBC 5000 are needed for any transcoding scenario.
deploying various signaling and media scenarios using Ribbon SBC Core platforms (Session Border Controller)
| || |
this document attempts to document some best practices and configuration examples for deploying Ribbon SBC platforms, deployments done under the auspices of the Ribbon Network Design group should always take precedence over generic recommendations if there are any differences.
|Text||TLS on the Sonus SBC|