Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Table of Contents

Excerpt

Command Completion

To enter a command string, type a portion of the command string with a question mark (?) . The CLI returns all the possible commands words that start with the combination of characters entered.

Code Block
VX# re?
reconfigure reset

The example above demonstrates that the string - re - is associated with two other commands that begin with the identical letter combination. Adding another letter to the entry string renders the entry unique enough to be associated with a single command, as demonstrated below.

Code Block
VX# rec
TEST# reconfigure
Info

To enable command completion, you only need to type enough characters to make the command entry unique.

Command Recall

To recall commands in the history buffer beginning with the most recent command, press Control+P . Repeat the key sequence to recall successively older commands.

To return to more recent commands in the history buffer after recalling commands with Control+P , press Control+N or the up and down arrows. Repeat the key sequence to recall successively more recent commands.

Showing Additional Arguments

If too few arguments are entered, the CLI responds with Incomplete command . Press Control+P to repeat the previous command entry. Then add a space and a question mark (?) to show the additional arguments.

Code Block
VX# show alarm ?
catalogs Show the alarm catalog file settings
log Show the alarm log file settings
VX# show alarm

When no more arguments are needed, CLI indicate this with <cr>.

Code Block
VX# show alarm log ?
<cr>
&nbsp;VX# show alarm log

Using Editing Commands

The CLI includes a set of editing key function. Use the key sequences indicated below to move the cursor around on the command line for corrections or changes.

Key sequence

Does

Control+A

Moves to the beginning of the command line.

Control+B

Moves back one character.

Control+C

Aborts the command line and gets a new prompt.

Control+D

Deletes to the right of the cursor. If the command buffer is empty, logs out.

Control+E

Moves to the end of the command line.

Control+F

Moves forward one character.

Control+G

Rings the bell.

Control+H

Deletes to the left of the cursor.

Control+L

Clears the screen.

Control+T

Transposes the character at the cursor and the character after the cursor.

Control+U

Clears out the command buffer.

Control+Z

If in configuration mode or any configuration submodes, returns to the main menu.

Escape+B

Moves back one word.

Escape+F

Moves forward one word.