Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Overview

Error rendering macro 'excerpt-include' : No link could be created for 'IP Trunk Group Blocking and Test Call Number Profile Support'.

Test Calls

When blockingMode is enabled in a particular sipTrunkGroup, the SBC blocks all the normal calls in either one or both the directions based on the blocking mode enabled except the test calls. The Sip Trunk Group blocking functionality does not impact the SBC test call processing. The test call functionality is required for the maintenance blocking between interconnected operator's networks.

Identifying a Test Call

The test calls received at the SBC carries calling party category indication as Test Call. The test call functionality is required for maintenance blocking between interconnected operator's networks. When the calling party's category is applied to indicate that the call is "test call," a cpc parameter with the value test is inserted in the P-Asserted-Identity header field of the initial INVITE request. When SBC sees cpc=test in the PAI header field, the call will be treated as test call.

Example:               

P-Asserted-Identity: <sip:user1@example.com;cpc=test >

P-Asserted-Identity: <sip:user1;cpc=test@example.com;user=phone>

The SBC identifies the call as test call by examining the cpc parameter received in the P-Asserted-Identity header field. Additionally, the SBC compares the received called number against the pre-configured test call numbers in the Test Call Number Profile and selects the PSX (either to send normal PSX or test PSX) for further routing. The SBC routes the test call based on the PSX response.

Configuring SBC Test Calls

To set the blocking direction under SIP Trunk Group, enter the following command:

% set addressContext <addressContext name> zone <zone name> sipTrunkGroup <SIPTG name> blockDirection <bothways | incoming | none | outgoing>     

To configure the test call numbers, enter the following command:

% set profiles services testCallNumberProfile <Name of profile> testCallNumber <test number1>

To associate the TestCallNumberProfile to the SIP Trunk Group, enter the following command:                   

 

% set addressContext <ADDR_CONTEXT_1> zone <ZONE_IAD> sipTrunkGroup <ELEANOR_TG_IAD_IMS_V4> services testCallNumberProfile

  • No labels