Skip to end of metadata
Go to start of metadata

REST API Method: PUT /rest/snmptargetaddress/{identifier}

Creates a SNMP Management Addresses Table given a specific Table ID.

The SBC Edge system allows you to define up to 10 SNMP management addresses.


HTTP Method


Requires Authentication:



Parameter Name Required Service Affecting Data Type Default Value Possible Values Description
sCommTypeNoNoEnum1Possible values:
  • 0 - snmpCommNone
  • 1 - snmpReadOnly
  • 2 - snmpreadWrite
SNMP community type. Only 'snmpReadOnly' is supported.
snmpCommunityYesNostringnone128 - Max Length SNMP community used for communicating with the manager.
snmpMgrAddrYesNostringnone256 - Max Length SNMP manager address(IP address or FQDN)
snmpTrapEnableYesNoint1Possible values:
  • 0 - Minimum
  • 1 - Maximum
Indicates if this manager accepts the traps. Default set to enabled(1), but can be disabled(0).
snmpVersionYesNoEnum0Possible values:
  • 0 - snmpV2
  • 1 - snmpV3
SNMP version to use for this SNMP manager.
usmUsernameYesNostringnone32 - Max Length USM username for SNMP v3 Manager.
authProtocolYesNoEnum2Possible values:
  • 0 - authNone
  • 1 - authMD5
  • 2 - authSHA1
Authorization Protocol for this SNMP manager.
EncryptedAuthPassphraseYesNostringnone128 - Max Length Authorization passphrase for this SNMP manager.
privProtocolYesNoEnum1Possible values:
  • 0 - privNone
  • 1 - privAES128
Privacy Protocol for this SNMP manager.
EncryptedPrivPassphraseYesNostringnone128 - Max Length Privacy passphrase for this SNMP manager.

  • No labels