This page describes the final deployment step produced by the Lync 2010 wizard for a UX in a Lync 2010 environment with a SIP Trunk Provider. Before you proceed, ensure you have completed the prerequisites.

Topology Overview

Using a SIP Trunk is a popular alternative to PSTN connectivity via PRI. The UX can be configured to connect an Enterprise's Lync environment to a SIP trunk using the automatic setup wizard as described in the section below.

Usage of the deployment wizard to configure the UX does not modify existing configuration. The wizard will simply add the new configuration elements to the UX.

Lync 2010 Setup Field Configuration

Enter the scenario configuration details based on your deployment settings:

Field Definitions

Scenario Information - Field Definitions

Scenario Description

Name describing the Lync setup.
(info) This value entered will be prefixed on all the UX configuration elements created by the Setup Wizard pertaining to this deployment.

Gateway Scenario

Select SIP Trunking for this deployment

SIP Properties - Field Definitions

No. of Channels

The number of SIP channels you would like the wizard to allocated in the SIP Signalling Group.
(warning) Make sure you have enough SIP licenses to account for the entered value.

Server Pool Host

The Pool name of the Lync Server 2010 (FQDN)

Port Number

The SIP Server Port number (via TLS) to use for sending and receiving SIP messages between UX and the Server Pool Host

Border Element Server

The FQDN or IP address of the Session Border Controller service provider

Protocol

The IP protocol to use for sending and receiving SIP messages between UX and the Server Pool Host

Port Number

The SIP Server Port number to use for sending and receiving SIP messages between UX and the Server Pool Host

Use Secondary Border Element Server

Select enable if you wish to have a secondary Session Border Controller service provider configured