The Sonus SBC 1000 allows you to configure the Identification information, Physical Data Layer, and Networking Layer for the Ethernet ports. If you want to change the IP Address, you must configure the associated Logical Interface or use the Modify Ethernet IP task found under the Tasks tab.
Applying configuration to Ethernet ports can cause brief disruption to IP connectivity.
To access the Ethernet Ports on the Sonus SBC 1000:
Specifies an alternative name for the interface; typically configured by the SNMP-based Network Manager.
Description for the port or interface. Maximum entry: 64 characters.
Configures auto-negotiation or a specific speed for the Ethernet port. The default value should be changed only when necessary.
Specifies auto-negotiation or a specific value for the duplexity of the Ethernet port. Valid entries: Auto, Full or Half. Default value: Auto. The default value should be changed only when necessary.
Specifies the type of Ethernet frames that can be received on this port.
The ASM 1 Ethernet port is limited to Untagged mode only.
Specifies the default VLAN to which untagged frames will be assigned when they are received on this port. Visible only when Untagged or All is selected from the Frame Type list box. For more information about VLANs, see Creating and Modifying VLANs.
Specifies the tagged VLAN(s) of which this Ethernet port is a member. Only user created VLANs can be selected. Visible only when Tagged or All is selected from the Frame Type list box. Since the ASM 1 Ethernet port is limited to Untagged mode only, the Tagged VLAN selection is not be present for this port.
Determines whether MSTP is enabled/disabled on the port(s). Valid options: Enabled (MSTP is enabled) or Disabled (default; MSTP is disabled and does not transmit/receive BPDU packets).