Before placing a VX system in service, complete the tasks identified in this section.
Verify that circuit breaker(s) are in the OFF position before connecting power to the chassis. The breaker(s) should be located on the Power and Alarm Panel mounted in the rack above the chassis.
Install, maintain, or replace this equipment only if you are trained and qualified as defined by AZ/NZS 3260 Clause 220.127.116.11 Service Personnel.
Always disconnect the power source to the system when work is done on or around the power supplies. Be sure you have a full understanding o high powered electronics components before servicing these components. Failure to follow this guideline could result in personal injury, death, damage to the equipment or loss of data.