Once you have completed the physical installation of the VX chassis, you must perform a bootstrap configuration of the VX unit before configuring it for your environment and placing it into service.

Bootstrap Configuration Information

Before performing the bootstrap configuration of the VX unit, gather the following information:

Information

Description

 

License

Software key or hardware dongle (HASP) provided with the VX unit. The HASP license key is the number located at the USB port of the VX chassis.

 

User Name

Choose an administrative user name for the VX unit.

 

User Password

Choose an administrative user level 0 password for the VX unit. Level 0 provides full administrative access.

 

IP Address

IP address for the VX unit

 

Subnet Address

Subnet mask for the VX unit

 

IP Default Router

IP address for the VX unit's gateway router

 

Node ID

VX node identifier (in decimal format)

 

Node Name

Text name for the VX unit

 

FTP User Name

(Optional) Choose a user name for FTP access to the VX unit.

 

FTP User Password

(Optional) Choose a user password for FTP access to the VX unit.

Attach VT100 Terminal

VX uses VT100 terminal communication to perform the bootstrap configuration, which requires a 9-pin serial cable and a VT100 terminal or PC equipped with a serial port and a terminal emulator application.

To attach a VT100 Terminal with Serial Cable:

  1. Connect a 9-pin serial cable to the VX unit. For help in locating the serial connector on the VX chassis, see the VX Chassis Types page.
  2. Connect the other end of the serial cable to a VT100 terminal or PC running a terminal emulator such as Microsoft HyperTerminal or PuTTY.

Perform Bootstrap Configuration

If your unit came with hardware dongle (HASP), DO NOT ATTACH the hardware key until prompted to do so.

To perform a bootstrap configuration of the VX unit:

  1. Verify that your VT100 terminal or emulator is attached via 9-pin serial cable, following the instructions above.
  2. Power on the VX unit.
    A copyright screen should appear in the VT100 terminal display.
  3. When prompted, press Ctrl-D to launch the setup script.

    If you receive a request for drives during setup, then you have attached the hardware dongle before being prompted. Cancel the setup, remove the dongle and restart the unit.

  4. Follow the on-screen prompts to complete the bootstrap configuration of the VX unit.

    To modify your settings, return to the beginning of the setup script by typing setup.

  5. Complete and save the configuration by typing exit.
  6. Apply the configuration settings by by typing restart.
    The VX unit is now configured and accessible on your IP network.

Next Steps